In-the-hoop Fall Leaf Potholder

It’s getting colder and winter is definitely on the way.

But if you’re not ready to say goodbye to autumn just yet, here’s a quick in-the-hoop project to keep those fall colours going a little longer.

This pot holder is made completely in the hoop of your embroidery machine with only a few stitches needed to close the gap where it’s turned through at the end. Perfect for stocking fillers, a hostess gift or extra help in the kitchen when you’re cooking for a crowd!

Use two colours of thread and contrast scraps for the leaves.

I added a pice of Insulbright (heat proof) wadding for heat protection and attached a hanging loop.

Stitches: 12084

You’ll need a hoop that can accommodate a design 178mm x 178mm (7″ x 7″)

Full instructions are included.

Available formats: DST; EXP; HUS; JEF; VP3; VIP; XXX. Need a different format? Message me and I’ll try to help.